Loveknot Pendant

Wire Loveknot Pendant

Designed by Denny Diamond © 2012

Skill Level: Intermediate

Technique: Wire forming with heavy gauge wire

This pendant is demonstrated using square copper wire for the frame, half round nickel silver for the links, and round bronze wire for the jump ring and bail wires. You may use any wire of your choice to either match or contrast the components, and half-hard temper seems to be more secure. Have fun! -Denny

Materials

  • 14-gauge dead soft half round wire, 38"
  • 14-gauge square wire, 8-3/4"
  • 16-gauge round wire, 3" for bail
  • Jump ring made from 1-3/4" of 16-gauge round wire (work off the coil)

Tools

Instructions

  1. Straighten and cut 18 pieces of 14-gauge half round wire, each 2-3/8" (6cm) long. Mark the centers of those wires at 3cm.
    Line Break
  2. Hold wire with flat nose pliers, then gently bend the wire, bending a loop on the edge of the half round wire. The rounded side should be up, and the flat side should be down.
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Line Break
  3. Use your pencil or dowel to keep the rounded loop, then pinch the wire ends together to close.
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Line Break
  4. Bend 2 loops gently: 1 piece with rounded side up, 1 with flat side up. Intertwine the pieces, alinging them with both rounded sides facing upward.
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Line Break
  5. Flatten one of the loops' ends. Using the smallest step of 3-step pliers, curl the ends coming out over the rounded (top) side of the link, until that end touches the flat side. Repeat on the other side, this time with the flat (bottom) side curling upward. This is your first knot.
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Wire Loveknot Pendant
    Line Break
  6. Make 1 jump ring from 16-gauge round wire, using a Sharpie marker as a mandrel.
    Wire Loveknot Pendant
    Line Break
  7. Make 8 more knots. Slide all knots onto the jump ring with the rounded (top) side of the curl outward.
    Wire Loveknot Pendant
    Line Break
  8. Twist the 14-gauge square wire into a nice bead, or diamond-cut, pattern. Wrap the twisted wire around a bottle or dowel approx. 2-1/8" in diameter, and mark where the wires meet.
    Wire Loveknot Pendant
    Line Break
  9. Measure 3/4" from the mark towards each end of the wire, and then cut off the excess.
    Line Break
  10. Using the middle step of 3-step pliers, make a loop so that one end meets the mark. Leave the other end straight.
    Wire Loveknot Pendant
    Line Break
  11. Thread the twisted wire through the flat side-showing end of the 9 knots. Finish top of frame with a loop matching the loop in step 10.
    Wire Loveknot Pendant
    Line Break
  12. Move knots evenly around circle and crimp firmly onto frame with flat nose pliers.
    Line Break
  13. Use 16-gauge round wire to make 2 s-shaped closed hooks to secure the frame loops as bails, or make a bail of your choice.
    Wire Loveknot Pendant
    Line Break

Check it out! Free Wire Jewelry Patterns

Did you find this pattern through a link from a friend? This Free Wire Jewelry Pattern is just one of dozens of free wire jewelry patterns we send via email. Get patterns like this one straight to your inbox - click here!