Get to Know Your Hand Tools The Hand Drill
by Helen I. Driggs
Lovers of twisted wire take note: A hand drill will change your life forever. When repurposed for metalwork, this simple tool can transform wire of any size and/or shape and/or strips of thin gauge metal sheet into interesting textured, twirled and twisted designs. All you need add is a hardware-store hook (or not) and have access to a sturdy bench or shop vise. Use twisted wire the same way you use other wire: make jump rings, wire wrap with it, or solder it to other fabricated metal parts and pieces for a decorative effect.
Instructions
What to know about hand drills

Hand drills are the precursors to the handy portable power drill that every home repair enthusiast knows and loves. What all drills do is simple: they employ a three-sectioned “Jacobs” chuck that can be opened and closed using a chuck key. Simply insert a drill bit or other attachment in the chuck and you are good to go. The drill motor spins a shaft that the chuck is mounted on and the speed of is controlled by a trigger control. In our case, the wire spins under hand power instead.

Tips for using a hand drill

Pro Tip: To use the hand drill, insert a hardware store “cup hook” into the Jacobs chuck and clamp it down tightly. Fold a length of wire in half and capture the two loos ends in the bench vise. Slide the U-shaped other end over the cup hook. Turn the handle on the drill. It helps to pull back from the vise to keep tension on the wire as you twist.
Pro Tip: Cranking clockwise or counter-clockwise will result in different twists, and so will different gauges of wire. A nice after effect with twisted wire is to then hammer it flat on a bench block.
Pro Tip: If you can’t find a hand drill, you can employ a hand-held power drill for these techniques, but take care and always wear goggles if you do because working at high speed may cause tightly twisted wire to snap more quickly than it might under human power.
HELEN I. DRIGGS is an experienced metalsmith, lapidary and studio jewelry instructor and has appeared in 6 instructional jewelry technique videos. Her book, The Jewelry Maker’s Field Guide was published in 2013.

Materials

No materials listed

Tools

3.6 Volt Automatic Wire Twister (Cordless Screwdriver)
G5-15
  • G5-15
  • Lesson Quantity: 1.00 pieces
  • Purchase Quantity: 1.00 each
  • Price: $42.97
  • Gold Club Price: $32.23
Add to Bag
Diamond Coated 3/32 Drill Bits - Set of 6
G26-55
  • G26-55
  • Lesson Quantity: 1.00 pieces
  • Purchase Quantity: 1.00 each
  • Price: $38.97
  • Gold Club Price: $29.23
Out of Stock
20 pc. 61-80 Small Gauge Drill Bits
G26-60
  • G26-60
  • Lesson Quantity: 1.00 pieces
  • Purchase Quantity: 1.00 each
  • Price: $4.97
  • Gold Club Price: $3.73
Add to Bag
Add All Items to Cart
  • Category: Tools
  • Technique(s): Coiling, Wrapping, Weaving, Design