Mark the center of the first long piece with curled ends.
Take a 2-foot section of 21 gauge half round wire.
Start wrapping from the center, 6 times.
Mark the end of these first six wraps.
Turn and wrap 6 times in the opposite direction, totaling 15 wraps.
The mark keeps you centered.
Place the first infinity.
Wrap each circle of the infinity three times.
Wrap the bar 10 times on both sides.
Attach the next infinity piece with 3 wraps.
Wrap 15 times between the next infinity ends, then wrap it 3 times.
Turn and repeat with the third infinity.
*Splicing the half round wire sections, do this in on just the bar section never in the infinity circle itself.
Leave off in a convenient place on the bar to start the next 21 gauge 2 foot section.
Leave a small tail and start next piece also leaving a small tail.
We will trim these later and bury inside later, leave the tails pointing towards the inside of the piece.